Restore Factory Defaults - Fluke LinkRunner AT 1000 User Manual

Highlight either the Report or Profile folder.
3
Highlight the file, then press
4
To edit the filename, press
5
 To delete characters in the filename, press
Delete.
 To add characters to the filename, use
highlight a character, then press
 To move the cursor in the filename, highlight the
filename, then press
To rename the file with the name you made, press
6

Save, then press
To delete a file
Select Tools > Manage files.
1
Select Delete file.
2
Highlight either the Report or Profile folder.
3
Highlight a file, then press
4

Press
5 Delete.
L
.

Edit.

  
L
.
 
.
Rename.
L
.

Restore Factory Defaults

Restores any configuration changes to the following
LinkRunner AT factory defaults.

IP Configuration:
IPv4: DHCP
IPv6: Disabled
to

VLAN/MAC Configuration:
VLAN: Disabled
VLAN ID: 0
Priority: 0

User Defined MAC: Disabled
MAC Address: Linkrunner MAC address

AutoTest Configuration:
Continuous Mode: On
Target: none

PoE Configuration:
Enable PoE: Disabled
Class: Class 1

Connect Configuration:
802.1x: Disabled
Speed/Duplex: Auto
Set Up the Tester
17