Page 2
FP Series Install Instructions For: 1.435.647.9555 800.647.TUBE www.soundtube.com FP6030-II and FP6020-II speakers 1. Unpack FP speaker pod 2. Thread signal wire through 3. Hand tighten dome clamp. 4. To use junction-box w/ and FP Dome. hole in dome and dome clamp.
Page 3
Warning Warning SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for Do not spec or install speaker near support beam, ventilation duct or optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
Page 5
(Figure 2). FP-Motion sensor instructions between 12 V and 18 V for settings and controls. (optional SoundTube Figure 2 accessory: AC-PS-1530) Figure 3 Connect the power supply to the brown/white (+) and brown (-) wires in the CAT 5 cable.
Page 6
2 – 12 seconds. external power supply rated As long as motion is detected, between 12 V and 18 V the module’s timer is (optional SoundTube continuously reset. Once no accessory: AC-PS-1530) motion is detected, the Connect the power supply to delay-off timer is activated.
Need help?
Do you have a question about the FP6030-II and is the answer not in the manual?
Questions and answers