SoundTube FP Series Install Instructions

FP Series
Amp, audio relay or continuous
audio jumper connection
Continuous audio jumpers [8]

Contents

1 FP-Motion module
5 Pairs audio relay jumpers
Wiring Instructions
Cat V wiring
All signal and control wires are located in the signal/hanging cable provided
with the FP unit speaker wires. A Cat V cable (blue shield) contains the control and power
wires; audio wires are individual 16 gauge wires in the bundle.
Power
Power = Brown/White
Power ground = Brown
FP Series
Warning
SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
Install Instructions For:
FP-Motion
Audio relay [7]
(ships with motion sensor only)
External controller
Contact closure = Green/White
Contact closure = Green
12v trigger = Blue/White
Amp control = Blue
1.435.647.9555
FP pod [2]
Motion sensor connection
Main electrical board
Pod cover screws [3]
LED Light
LED control = Orange/White
LED control = Orange
Amp Control
Amp gain = Blue
Amp gain = Orange
1.435.647.9555
© 2010 SoundTube Entertainment, Inc. All rights reserved. PN INS-FP-MOTION Rev03.18.10
Warning
Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.
| |
800.647.TUBE www.soundtube.com
FP modules ship pre-installed
from the factory.
Other FP Series optional
modules include:
1. LED Light
2. ScentAir
3. Amp
All modules require a power source.
An optional 15 volt source is
available from SoundTube
(Model numbers: AC-PS-1530
or AC-PS-1550).
Motion sensor trim pot [6]
(delay off timer)
Motion sensor module
Motion sensor narrow aperture [4]
Motion sensor
wide aperture [5]
Pod cover [1]
Speaker
Left in = White
Left in = Green
Right in = Red
Right in = Black
| |
800.647.TUBE www.soundtube.com