JinkoSolar JKM M-72HL4-BDVP Series Installation Manual page 16

Module type
Group 1
Group 2 & Group 7
Group 3
Group 4 & Group 8
Group 5
Group 6
Group 13
Group 19 & Group 20
Group 21 & Group 22
Group 23 & Group 24
Group 25 & Group 26
Group 27
Group 28
Table 5: Mechanical dimensions when modules installed with bolts fitting method
Note：The installation method of bolt fitting is based on the experimental results inJinko.
2.3.2.2 Fixation with clamps at long sides of frames
The module clamps should not come into contact with the front glass and must not deform the
frame. Be sure to avoid shadowing effects from the module clamps. The module frame is not to
be modified under any circumstances. When choosing this type of clamp-mounting method,
please be sure to use at least four clamps on each module, two clamps should be attached on
each long sides of the module. Depending on the local wind and snow loads, if excessive
pressure load is expected, additional clamps or support would be required to ensure the module
can bear the load. The applied torque value should be big enough to fix the modules steadily
(Please consult with the clamp or support's supplier for the specific torque value). Please find
detailed mounting information in the below illustration, the mounting place distance is suggested
Dimensions（mm）
Maximum designed mechanical load : 3600Pa
(positive ) & 1600Pa (negative)
Frame
1984*998 & 1984*992
40
2009*1008 & 2023*1018
40 2000*992 & 2031*1008 & 2054*1018
1674*998 & 1686*1008
35
1699*1018 & 1656*992
1698*998 & 1680*992
35
1704*1008 & 1727*1018
40
35
30 2223*1025 & 2255*1032
1701*1122 & 1717*1132
30 1719*1134 & 1669*1122
1685*1132 & 1678*1134
1884*1122 & 1901*1132
30 1904*1134 & 1868*1134
1865*1132 & 1848*1122
2027*1122 & 2046*1132
30 2049*1134 & 2089*1134
2086*1132 & 2067*1122
2274*1134 & 2278*1134
30
2385*1122 & 2393*1130
30
2408*1132 & 2411*1134
30&35
-14-
A*B
1974*998
1664*998
& 2230*1134
2465*1134