Table of Contents
Advertisement
■
Never blow through nozzles or other components by
mouth.
■
Avoid contact with chemicals. Immediately change
clothing that are contaminated with plant control
chemicals.
■
Do not aim the nozzle towards persons, animals, and
electrical equipment.
■
Do not operate the product in windy conditions. Always
aim downwind.
■
Avoid using the product in freezing weather because the
solution may freeze.
■
Too high or too low pressure or unfavorable weather
conditions can result in the wrong solution concentration.
Overdosing may damage plants and the environment.
Underdosing may result in unsuccessful plant treatment.
■
To reduce the risk of damage to the environment and
plants, do not operate the product:
●
if pressure is too high or too low
●
in windy conditions
●
in direct sunlight
■
To reduce the risk of accidents and damage to the
product, never operate with:
●
flammable liquids
●
viscous or sticky liquids
●
caustic or corrosive chemicals
●
liquids hotter than 50°C
■
Clean the product after each use.
ADDITIONAL BATTERY SAFETY WARNINGS
■
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse the tool,
battery pack, or charger in fluid or allow fluid to flow
inside them. Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and bleach or
bleach-containing products, etc., can cause a short
circuit.
■
Charge the battery pack in a location where the ambient
temperature is between 10°C and 38°C.
■
Store the battery pack in a location where the ambient
temperature is between 0°C and 20°C.
MAINTENANCE
■
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can cause
possible injury, can contribute to poor performance, and
may void your warranty.
■
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. Have the product serviced by an authorised
service centre only.
■
To avoid serious personal injury, always remove
the battery pack from the product when cleaning or
performing any maintenance.
■
After each use, check all parts of the product for leaks.
Return the product to an authorised service centre for
repair if necessary.
■
Drain and empty the spray tank before cleaning.
■
Drain the spray materials through the fill area.
4
Original Instructions
NOTE: Drain all of the spray materials from the spray
tank into a container approved for chemicals. Do not store
chemicals in the spray tank.
■
Use clean water to clean and rinse the spray tank. A
small amount of mild household detergent may be
added.
■
Wipe the product with a clean, dry cloth.
■
It may be necessary to rinse the spray tank more than
once.
DISPOSAL
■
Never dispose of residual chemicals or contaminated
rinsing solutions in waterways, drains, sewers, street
gutters, or manholes.
■
Dispose of residual chemicals, contaminated rinse
water, and used containers in accordance with local
waste disposal regulations.
TRANSPORTATION AND STORAGE
■
Turn off the product, remove the battery pack, and allow
both to cool down before storing or transporting.
■
Drain all spray materials from the spray tank before
storing and transporting.
■
After each use, check all parts of the product for leaks.
Return the product to an authorised service centre for
repair.
■
Ensure that all parts of the product are clean and dry.
■
Remove all foreign materials from the product.
■
The spray wand can be stored in the cradle.
■
For transportation, secure the product against movement
or falling to prevent injury to persons or damage to the
product.
■
Store the product in a cool, dry, and well-ventilated place
that is inaccessible to children. Keep the product away
from corrosive agents, such as garden chemicals and
de-icing salts. Do not store the product outdoors.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps or
tape. Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.
SYMBOLS ON THE PRODUCT
Safety alert
Regulatory Compliance Mark (RCM).
The product meets applicable
regulatory requirements.
Read and understand all instructions
before operating the product. Follow all
warnings and safety instructions.
Advertisement
Table of Contents
