Chemical Safety - Quansys Q-View IMAGER LS Operator's Manual

6
1. Ensure the new location meets the requirements
addressed in Placement in the Laboratory
(page 2)
2. Remove any remaining
plates on the tray
3. Remove
insert
4. Close Q-View Software on
the PC
5. Remove all cords from
the device
6. With a piece of tape, tape
the lid down so it doesn't
open during transit
7. Insert the Q-View Imager LS into the provided
plastic sleeve
8. Insert the glass/tray insert into the protective
sleeve
9. Bundle and tie cables together
10. Insert the Q-View Imager LS into the foam
insert in the Q-View Imager LS box
11. Place the glass/tray insert, and cords into the
box

CHEMICAL SAFETY

The only chemicals used with the Q-View Imager LS
are deposited within the wells of the plate, which is
placed on the glass/tray insert. It is important to take
precaution that these chemicals do not spill onto the
glass/tray insert. If any spillage occurs on the glass/
tray insert, clean it immediately before closing the
lid. If liquids are present on the glass/tray insert,
they may drip onto the camera lens and damage the
Q-View Imager LS.
the glass/tray
For Research Use Only