Table of Contents
Advertisement
4.8 Footplate to seat distance adjustment
The telescopic footplate support is inserted into the front
frame of the wheelchair and secured through the two "E"
screws.
The height can be adjusted at 2 cm steps:
Unscrew and remove the "E" screws, securing the
•
footplate to the frame;
Slide the footplate to the appropriate height;
•
Insert again and tighten properly the "E" screws
•
4.9 Setting the real wheel camber
The rear wheel camber is set according to the order form selection. It is however possible to
change it if required over time replacing the bush with a new with different camber.
• Remove the wheels;
• Loosen the clamp holding the bush in place;
• Swap the bush with the one with the new desired angle;
• Place the camber bush with the camber in the correct direction and with the
two flat surfaces approximately perpendicular to the ground;
• Before tightening the clamp, be sure to check the wheel alignment as follows:
Insert the rear wheels and check the distances
o
between them (d
front and on the back at the level of the hub as
shown in the figure;
b1 and b2 have to be equal;
o
o
check the a distance from frame to wheel
and verify if it is equal both on the left and
on the right side;
If the distances are equal on both sides, tightly
o
fix the clamp.
and d
), measured on the
1
2
13
Advertisement
Table of Contents
