Remove the upholstery cover and loosen the
•
tensioning velstraps (see par.4.5) to reach the
"A" screws that connect the handles tube and
the frame;
Remove both "A" screws;
•
Lower or raise the handles until reaching the most suitable height (the tubes
•
are pre-holed with 2 cm steps);
Insert again the "A" screws and screw them firmly;
•
Set the correct backrest tension and fold properly the upholstery cover (see
•
par.4.5).
The same procedure can be also followed if the
pushing handles are height adjustable.
A similar procedure can be also followed to change
the extention backrest tubes when the wheelchair is
configured without pushing-handles.
4.7 Height adjustable pushing handles
If the wheelchair is equipped with height adjustable pushing
handles it is possible to adjust them as follows:
Loosen the clamp unscrewing the "B" knob;
•
Choose the most suitable position for the push-handle;
•
Tighten the "B" knob properly;
•
Turn the "B" knob in an appropriate position;
•
Note: the "B" knob is a special spring lever. To change its position it is possible to pull out
the lever, turn it in the desired position and release it again.
12