Replacing The Front Castors; Backrest Tension Adjustment; Backrest Height Adjustment - OFF CARR IDRA 2.0 Instruction Manual

4.4 Replacing the front castors

If necessary, the front castor can be replaced:
• Completely unscrew one of the "D" screws and
remove the "E" pin being careful to where the "F"
spacers are;
• If necessary, change the wheel;
• Position the wheel hub align with the most suitable
fork hole;
• Insert the "E" pin, being careful to keep the "F"
spacers in their original sequence;
• Fix properly the "D" screw.
Be sure to choose the same position for both castors. Asymmetrical combinations
produce instability.
Be careful not to change the front seat height while changing the front castors
because this will modify the perpendicularity to the ground of the front fork roataing
axle.

4.5 Backrest tension adjustment

The backrest tension can be adjusted by acting on the
velstraps:
• Fold up the "B" upholstery cover of the
backrest;
• Adjust the upholstery tension by opening or
closing the disclosed velstraps;
Fold down the "B" upholstery cover back in
•
place;

4.6 Backrest height adjustment

The backrest height will be assembled according to the order form selection. It is however
possible to change it over time.
If the wheelchair is equipped with pushing handles it is possible to move them up or down of
a few centimetres as shown:
11