Making An Id Label; Applying An Id Label - Brother Stampcreator PRO SC-2000USB Operation Manual

Making an ID label

After engraving the stamp, we can print the same layout on a label that can
be attached to the stamp for easy identification. In order to see how the
stamp will appear when it is engraved, the ID label can be printed before
engraving the stamp.
1 Insert an ID label sheet, so that the words "ID LABEL" can be read,
straight into the narrow ID label slot to the right of the draft tray slot.
NOTE: Be careful not to touch the print area of the
ID label sheet since dust, fingerprints, hand
creams, etc. may prevent the characters
from being printed correctly.
Be sure that the ID label is the correct size.
Do not use an ID label that has been folded.
• ID labels for smaller size stamps (1212, 2020, 3030, 4040, 1060, and
1438) have two printing areas on each label. Print labels in the lower
portion first, and then save the unused portion for future use. The machine
will always print on the lower portion.
2 With the layout of the engraved stamp displayed in Stampcreator P-
touch Editor, select the Print command in the File menu.
Or click in the Print Properties. The Print dialog box appears.
3 Select "ID Label", and then select the appropriate setting in the "Docu-
ment Type" drop-down list.
Insert an ID label sheet into the ID label slot of the SC-2000USB, and
then click the Print button to start printing the ID label.
NOTE: For details on printing an ID label with
Stampcreator Express, refer to page 35.
• The ID label will automatically be fed from the slot on the top at the right
end of the machine.

Applying an ID label

After the label has been printed and fed from the exit slot on the top at the
right end of the SC-2000USB, remove it, peel off the ID label from its back-
ing paper, and then affix the ID label to the top of the grip.
NOTE: Some stamps, such as the 4090, 3458, and
4040, have an L-shaped ID label. When
attaching this type of ID label, apply the
short side first, and then apply the remaining
side to the stamp grip.
DESIGINING A STAMP
MAKING A STAMP
ID label slot
ID label
Grip
43