Brother Stampcreator PRO SC-2000USB Operation Manual page 17

Loading draft sheets and installing the draft sheet magazine tray
1 Slide the magazine tray out from its outer case.
2 Lift up the magazine tray lid.
3 Place the draft sheets (with the words "DRAFT SHEET" facing up) into
the magazine tray so that the corners of the sheets fit under the tabs in
the front corners of the tray.
NOTE: No more than 50 draft sheets should be
loaded into the magazine tray.
Be sure that there is no dust, fingerprints,
etc. on the draft sheets.
Do not use a draft sheet that has been
folded.
Be sure that a cleaning sheet is not
accidentally inserted together with the draft
sheets.
Cleaning sheets are to be used to clean the
inside of the machine (see page 44). Be sure
to separate the cleaning sheets from the
draft sheets.
4 Close the magazine tray lid.
5 Slide the magazine tray back into its outer case.
6 Fully insert the magazine tray straight into the draft sheet magazine tray
slot.
NOTE: Be careful not to pinch your fingers while
inserting the magazine tray.
To remove the draft sheet magazine tray,
grab its outer case, and then pull out the
entire magazine tray.
After installing the ink ribbon cassette and the magazine tray loaded with draft sheets, you can use the Stampcreator P-
touch Editor software or Stampcreator Express software to create any layout containing graphics and text, and then engrave
it into a stamp.
SET UP
2
3
1
Draft sheet magazine tray
Draft sheet magazine
tray slot
13