Rainwater Collector; Connection To The Rainwater Barrel - FLORABEST FRWS 9 A1 Assembly Instructions Manual

Rainwater collector

GB

Connection to the rainwater barrel

4
NOTICE
► With a downpipe size of 70 mm you will need to cut off the rubber tabs at
the indentations with scissors (see Figure G).
1. Select the fl ange (
Take note of the size details indicated on the inside of the fl anges.
2. Glue one of the fl ange gaskets
the fl ange. To do this, remove the adhesive backing from the fl ange gasket
(see Figure H).
3. Guide the clamping device
that the guides in the fl ange grip the rails on the clamping device. Press the
two parts fi rmly together, so that the clamping device engages (see Figure. I).
4. Turn the nut of the clamping device open such that there is suffi cient space
between the snap hook and fl ange. If need be, push the O-ring back (see
Figure I).
5. Insert the clamping device into the hole in the downpipe. Thereby, press the
clamping device upwards slightly and then press it fi rmly into the downpipe
(see Figure I).
6. Turn the clamp nut clockwise until it is hand tight (see Figure I).
7. Moisten the outer sides and the neck of the rubber tabs with detergent
(see Figure J).
8. Press the rubber tabs together and slide them through the opening of the
clamping device into the downpipe. Ensure that the tongued and grooved
connection between the clamping device and rainwater collector interlocks
correctly (see Figure J).
1. Insert from outside the supplied rubber seal DN 19/32
rainwater barrel.
2. Moisten the end of the connecting hose
3. Firmly press the connection hose through the rubber seal DN 19/32.
4. Connect the rainwater collector
tion hose (see Figure K).
or ) appropriate to the size of your downpipe.
into the recess provided on the inside of
through the fl ange. When inserting it, ensure
with detergent.
and the rainwater barrel with the connec-
in the hole of the
FRWS 9 A1