Gas Heat Operation; Dry-Air Operation; Auto Change Over Operation - Airxcel RVP INFRARED REMOTE CONTROL SYSTEM Operating Instructions Manual

Table of Contents

GAS HEAT OPERATION

(If gas heat appliance is connected to upper unit)

Gas Heat symbol

Select gas heat by pressing the "MODE" button until the gas heat symbol is

displayed.

Set temperature to the desired level by pushing the up(+) or down(-) button.

Dry-air symbol

Select the dry-air mode by pressing the "MODE" button until the dry-air

symbol is displayed.

Set temperature to the desired level by pushing the up(+) or down(-) button.

In the dry-air mode, the compressor & fan will cycle on and off at different

timing intervals depending on the setpoint. If the temperature is above the

setpoint, the on cycle is longer than the off cycle to help maintain setpoint. If

the temperature is below the setpoint, the off cycle is longer than the on cycle

to help maintain setpoint.

Auto change symbol

Select the auto change over mode by pressing the "MODE" button until the

auto change symbol is displayed.

Set temperature to the desired level by pushing the up(+) or down(-) button.

(Note: In the auto change over mode the unit will maintain a comfortable

temperature throughout the room without the trouble of having to select heat

or cool mode. A gas heat appliance and air conditioner must be present and

operational before this feature can operate.)

Table of Contents

Do you have a question about the RVP INFRARED REMOTE CONTROL SYSTEM and is the answer not in the manual?