Airxcel MAXXFAN MINI DELUXE 3805 Installation Instructions, Information And Operating Manual

MAXXFAN MINI DELUXE
INSTALLATION INSTRUCTIONS,
INFORMATION AND OPERATING GUIDE
FOR MODELS 3805, 3855, 3806, 3856,
READ AND SAVE THESE INSTRUCTIONS
NOTE: Refer to Installation Instructions, Information and Operation Guides regarding the
model you have purchased.
The MAXXFAN MINI Deluxe installs into a standard RV roof opening of 14 by 14 inches.
To determine if your roof opening is correctly sized, simply remove the interior ceiling
garnish trim ring of your existing roof vent and measure the ceiling opening or verify the
opening is large enough by sliding the MAXXFAN MINI Deluxe sleeve into the opening.
The MAXXFAN MINI Deluxe is designed for a minimum roof thickness of 1 inch to a
maximum of 6 inches.
The MAXXFAN MINI Deluxe requires a minimum 12 Volt DC, 2 amp service. Confirm that
the circuit you intend to use will accommodate the additional load. Circuit must be fused
and use appropriate gauge stranded wire for electrical connections.
WARNING!
TO PERSONS, OBSERVE THE FOLLOWING:
a) Use this unit in the manner intended by AIRXCEL, INC. If you have questions,
contact the manufacturer.
b)
Before servicing or cleaning unit, switch power off at service panel and lock the
service disconnecting means to prevent power from being switched on
accidentally. When the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the service panel
CAUTION!
FOR GENERAL VENTILATION USE ONLY. DO NOT USE TO
EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS AND VAPORS.
P/N: 10A03893Z
3807, 3857
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
.
05-24-2019