Notes On Clipping The Inverter Into The Wall Bracket; Clipping The Inverter Onto The Wall Bracket - Fronius Primo 3.8-1 208-240 Installation Instructions Manual

Notes on Clipping the Inverter into the Wall
Bracket
Clipping the In-
verter onto the
Wall Bracket
The fixing screws in the data communication area of the inverter are used to fix
the inverter to the wall bracket. Fixing screws must be properly tightened to en-
sure correct contact between the inverter and the wall bracket.
Danger of damaging the inverter due to improperly tightened fixing screws.
Improperly tightened fixing screws may cause arcs to occur when the inverter is
operated, which may lead to fire. Always tighten the fixing screws with the spe-
cified torque.
40
ON
OFF
Lock
22.1 lbf.in / 2.5 Nm
CAUTION!
The side areas of the housing cover are
designed to function as carrying grips
and/or handles.
NOTE!
The inverter is fitted with a lock for
safety reasons, which allows the in-
verter to be pivoted in the wall bracket
only when the DC main switch is off.
▶
Only clip on and pivot the inverter
in the wall bracket when the DC
main switch is off.
▶
Do not use excessive force to clip
on the inverter and pivot it.