Table of Contents
Advertisement
When this option is enabled, the existing component in the System Recovery Set is replaced by the selected
component when the task is complete.
Selecting this option replaces the component, even if the version in the System Recovery Set is newer.
This option is not displayed if:
•
A command is selected.
•
There is no System Recovery Set.
•
Your user account is not assigned the required privilege.
8. If the server has a TPM or TM, suspend or back up any software that stores information on the TPM or TM, then select
the Confirm TPM override check box.
Drive encryption software is an example of software that stores information on the TPM or TM.
CAUTION: If you use drive encryption software, suspend it before initiating a firmware update. Failure to follow
these instructions might result in losing access to your data.
9. Click OK.
iLO notifies you that the task was updated.
If the task would expire before the start time of a task that precedes it in the queue, iLO notifies you that it cannot
save the task. The installation queue is a first-in, first-out list of tasks, and you cannot create a task that will expire
before an existing task will run.
If you selected the Update Recovery Set check box, the component is updated after the task is initiated and
completed successfully.
Removing a task from the installation queue
Prerequisites
Configure iLO Settings privilege
Procedure
1. Click Firmware & OS Software in the navigation tree, and then click Installation Queue.
2. Click the remove component icon
iLO prompts you to confirm the request.
3. Click Yes, remove.
The component is removed.
Removing all tasks from the installation queue
Prerequisites
•
Configure iLO Settings privilege
•
The component is not in an install set.
•
The component is not part of a queued task.
.
62
Using HPE iLO 5
Advertisement
Table of Contents
