®
Flowmax
54i
Planning information
1. Planning information
1.1 Areas of application
The flow measurement device Flowmax 54i is designed to measure dynamic flow
in pipes and tubes. This flowmeter is suitable for liquids only. The Flowmax 54i is
used in
• Chemicals supply for controlling, logistics, monitoring
• Cooling systems, logistics, monitoring
• Process equipment for control and monitoring of formulas
• Valve control for continuous release of liquid volumes
• Supply with de-ionized water
• Very dynamic liquid processes with dosing times of below 1 second
Flowmax 54i has the following features and benefits:
• No movable parts, therefore no wear
• High repeatability
• Easy to clean
• Safe operation
• Compact design
• Integrated detection of empty conduits
• Integrated dosing function with pre-set and adjustable amounts
• Chemical resistant
• Constant pipe cross-section over the entire measurement channel
1.2 Measuring principle
It usually takes more energy to swim against the flow than with the flow. The
ultrasonic flow measurement is based on the phase-difference approach:
Two ultrasonic-sensors located opposite from each other alternatively
transmitting and receiving ultrasonic signals. If there is no liquid flow both sensors
receive the transmitted ultrasonic signals in the same phase, i.e. without phase
difference. If liquid is flowing there is a phase shift. It differs when measured in
direction of the flow than when measured against the direction of the flow. This
phase difference is directly proportional to the flow rate.
Figure 1: Presentation of the principle of ultrasonic flow measuring
M I B
5
Need help?
Do you have a question about the Flowmax 54i and is the answer not in the manual?