Installing The Driver - Vexta CFK II Series Operating Manual

Installing the driver

Installation method
Install the driver on a flat metal plate having superior capacity to withstand vibration as
well as a high heat-conductance effect. Always install the driver using the driver's
installation holes and install and fasten it either vertically or horizontally with the two screws
(M3; not supplied with unit) so that there is no gap between the driver and the metal plate.
Any other installation method will reduce the heat-radiating effect for the driver.
Illustrations show the DFC5128T.
There must be a clearance of at least 0.98 in. (25 mm) and 1.97 in. (50 mm) in the
horizontal and vertical directions, between the driver and enclosure or other equipment.
When two or more drivers are to be installed side by side, provide 0.79 in. (20 mm)
clearances in the horizontal.
Note
• Do not install any equipment that generates a large amount of heat near the driver.
• Check ventilation if the ambient temperature of the driver exceeds 104°F (40°C).
M3 screw
M3 tapped hole
Spring washer
Washer
M3 tapped hole
0.79 in. min.
(20 mm)
Washer
Spring washer
M3 screw
15