Installing A Load - Vexta CFK II Series Operating Manual

Installing a load

When connecting a load to the motor, align the centers of the motor's output shaft and
load shaft.
Direct coupling
Align the centers of the motor's output shaft and load shaft in a straight line.
Using a belt drive
Align the motor's output shaft and load shaft in parallel with each other, and position both
pulleys so that the line connecting their centers is at a right angle to the shafts.
Using a gear drive
Align the motor's output shaft and gear shaft in parallel with each other, and let the gears
mesh at the center of the tooth widths.
Note
• When coupling the load to the motor, pay attention to the centering of the shafts, belt
tension, parallelism of the pulleys, and so on.
Securely tighten the coupling and pulley set screws.
• Be careful not to damage the output shaft or bearings when installing a coupling or
pulley to the motor's output shaft.
• Do not modify or machine the motor's output shaft.
Doing so may damage the bearings and destroy the motor.
13