Advertisement
Power DALI push-button controller TW
The LED lights up blue and the luminaire switches to the coldest colour tem-
perature.
￭
To change the coldest colour temperature, press and hold the button Test for
longer than one second.
The LED flashes blue and the luminaire slowly starts to warm up at the coldest
colour temperature (10,000 K).
￭
Release the button Test as soon as a change in the colour temperature is vis-
ible on the luminaire.
The LED lights up blue, the coldest colour temperature is saved.
￭
To change the warmest colour temperature, press and hold the button Test for
longer than one second.
The LED flashes red and the luminaire slowly starts to cool down at the
warmest colour temperature (2,000 K).
￭
Release the button Test as soon as a change in the colour temperature is vis-
ible on the luminaire.
The LED lights up red, the warmest colour temperature is saved.
￭
To exit the setting mode, briefly press the button Test again.
Resetting the insert to factory settings
Precondition: Load is switched off.
￭
Press the Test button for at least 20 seconds.
The red LED lights up.
￭
Release the button and press it briefly once again within 10 seconds.
The red LED flashes three times.
The insert is reset to default setting.
5
Technical data
Rated voltage
Mains frequency
Power consumption
Rated voltage DALI
Output current
Short-circuit current
Ambient temperature
Colour temperature setting
Number of DALI subscribers
Number of parallel control units
82598933
J0082598933
8 / 9
AC 230 V~
50 / 60 Hz
max. 2.8 W
DC 16 V (typ.)
max. 36 mA
max. 60 mA
-5 ... +45 °C
2,000 ... 10,000 K
max. 18
max. 4
19.08.2022
Advertisement
