Table of Contents
Advertisement
402
Driver Monitoring System
& Handling of the sonar sen-
sors
The 4 sonar sensors are located in the rear
bumper. To ensure the proper operation of
the Reverse Automatic Braking (RAB)
system, observe the following precau-
tions.
. Do not affix any stickers or other items
on the sonar sensor or the bumper
surface near the sonar sensors.
. Always keep the rear bumper surface
near the sonar sensors clean.
. Do not modify the rear bumper.
. Do not paint the bumper near the sonar
sensors.
. Do not apply high pressure water to the
sonar sensors with a high pressure
carwashing machine.
. Do not apply strong impacts to the rear
bumper near the sonar sensors. If a
sensor becomes misaligned, a system
malfunction may occur, including in-
ability to detect objects in the reversing
direction. If any strong impact is applied
to the rear bumper, contact a SUBARU
dealer to have the system inspected.
. Do not disassemble the sonar sensors.
NOTE
If the sonar sensors require repair or
replacement, or if the area of the rear
bumper near the sonar sensors re-
quires repair, paintwork or replace-
ment, contact your SUBARU dealer for
assistance.
7-19. Driver Monitoring Sys-
tem (if equipped)
Driver Monitoring System is introduced as
DriverFocus in some countries.
The Driver Monitoring System monitors
possible cases when the driver is not
paying attention to the forward direction,
and also recognizes individual users.
This system warns the driver of inattentive/
drowsy driving, and can support safe and
comfortable driving by automatically re-
trieving the following settings.
– Driver's position
– Climate control setting
– Meter setting
– Center information display setting
When a user is registered, various settings
are automatically retrieved when the user
enters the vehicle.
Advertisement
Chapters
Table of Contents
