Scsi Port Error Log - HP StorageWorks A7298A Manual

Table 4–2 describes the SCSI port error log codes
Table 4–2: SCSI Port Error Log Codes
0x10
Offset
0xC0 Invalid Link Speed Selection
(Windows NT)
0xD0 SNS_REQ (XMIT_SEQ failed)
0xD1 SNS_RSP (RCV_SEQ failed)
0xD3 RCV_ELS_REQ failed
0xD4 XMT_ELS_REQ failed
0xD5 Too many targets found (160+)
0xD6 SNS request time-out
0xD7 Mailbox interrupt time-out
0xD8 TPRLO requested when busy
0xD9 Link down time-out occurred
0xDA Hard link down time-out occurred
0xE0 Node purged from configuration
(Windows NT)
0xE1 Error interrupt occurred
0xE2 Mailbox cmd time-out
0xE3 Mailbox rsp err
0xE4 HBA not ready after init
0xE5 Requested loop but link = PT-PT
0xE6 Mailbox int. but cmd not complete
0xE7 SRB already queued to ring
0xE8 RESTART failed
0xE9 PORT BYPASS (LPB) received
0xEB Unknown IOCB cmd rsp
host bus adapter for Windows and Linux installation guide
Explanation 0x11 to 0x13 Further Information
0x11 = cmdstat, 12 = parm err
0x11 = cmdstat, 12 = parm err
0x11 = cmdstat, 12 = parm err
0x11 = cmdstat, 12 = parm err
0x11 to 13 = D_DID that didn't fit
0x11 to 13 no additional information
0x11 = mailbox word 0
0x11 = local req. state, 12 = discstate,
13 = mailbox word 0
0x11 = local req. state, 12 = discstate,
13 = mailbox word 0
0x11 = local req. state, 12 = discstate,
13 = mailbox word 0
0x11 to 0x13 = D_ID of node purged
Status register bytes 1-3 in event 11-13.
E1 error indicates an HBA hardware
failure, return HBA for repair.
0x11 = command
0x11 = command, 12-13 = mbxstatus
Status register bytes 1-3 in event 11-13
0x11 = MB cmd, 12-13 = mbxstatus
0x11 = 15:8 = cmd field
Troubleshooting
4–3