Table of Contents
Advertisement
Diagnostic and Configuration Utilities
Installing the DOS Diagnostic Utility
You must load the software and start the diagnostic utility from the DOS command
line. You can run the program directly from the supplied software kit or you can load
onto your hard drive and run it from there.
NOTE: The diagnostic utility does not operate in the DOS shell under Windows.
To install the utility onto the hard drive:
1. Insert the supplied diskette into your system's diskette drive.
2. Make a directory and copy the files onto your hard drive, as follows:
C:\MD_DIRNAME
C:\COPY A:\i386\*.*C:\
DIR_NAME
C:\CD
DIR_NAME is the directory where the you install the diagnostic software.
Starting the DOS Diagnostic Utility
To start the program without any options, enter:
X86DNLD.EXE
The options for X86DNLD are listed in
A:\X86DNLD.EXE {I = infilename} {o = outfilename}
The following example shows a sample command:
C:\ X86DNLD.EXE o = PCIHA001
is the output filename.
PCIHA001
Table 5–1: DOS Diagnostic Utility Command Options
Option
Infilename
Outfilename
NOTE: All message lines except user input begin with a number symbol (#) to indicate a
comment line. Data entered by the user appears on a line by itself, not preceded by a #.
5–2
DIR_NAME
Script input file that is read and executed by the program.
Creates a file of keystrokes that is stored for later use (for example,
as an input file).
host bus adapter for Windows and Linux installation guide
Table
5–1. The syntax for using options is:
Description
Advertisement
Table of Contents
