Troubleshooting Hp Storageworks Xp Virtualization Adapter; General Troubleshooting; Error Messages On Srm Log Files - HP StorageWorks XP10000 - Disk Array Administrator's Manual

6 Troubleshooting HP StorageWorks XP
Virtualization Adapter

General troubleshooting

Use the following solutions to troubleshoot general issues:
XP disk arrays do not appear in Site Recovery Manager
Solutions
If XP disk arrays are not appearing in Site Recovery Manager, make sure that Site Recovery
Manager has been restarted (see step 3 in
Make sure that the array manager that SRM is connected to is actively managing arrays.
XP Virtualization Adapter does not install
Solution - Check that SRM is installed. HP StorageWorks XP RAID Manager XP Virtualization Ad-
apter will not install if SRM is not on the disk array.
Virtual machines do not start at recovery site after failover.
Cause - The ESX recovery hosts are not configured with the correct HBA port WWN on the recovery
XP.The replicated LUNs used in failover were not presented to the recovery ESX servers.
Virtual machines do not start at recovery site during failover testing
Cause - The ESX recovery hosts are not configured with the correct HBA port WWN on the recovery
XP.
.

Error messages on SRM log files

XP Virtualization Adapter error messages are identified in the SRM log files with XP Virtualization
Adapter shown in the message. To identify the XP Virtualization Adapter error messages, search the
SRM log files for XP Virtualization Adapter.
SRM log file is located in the following directory (default):
C:\Documents and Settings\All Users\Application Data\VMware\VMware Site
Recovery Manager\Logs\vmware*.log
NOTE:
• Logs rollover after reaching 5 MB by default
• vmware-dr-index contains the most recent Log File number
"Installation procedures" on page 23).
XP Virtualization Adapter Administrator Guide 39