Ryobi RY36BI1800A Manual page 8

Heat overload
Press reset
High temperature
warning
or
Low temperature
warning
Press reset
High temperature
shutdown
or
Low temperature
shutdown
Low voltage warning
Press reset
Low voltage shutdown
System fault
8
Original Instructions
The inverter temperature is
out of the normal operating
range.
The product is nearing the
maximum high or minimum
low operating temperature.
The product is outside
of the normal operating
temperature range.
The battery packs do not
have sufficient charge to
run the connected devices.
The battery packs are
discharged.
There is an internal
communication error.
Allow the product to cool down
and reach the normal operating
temperature.
Press the reset button to reset the
AC output.
Allow the product to cool down
or warm up as needed to an
acceptable temperature, then press
the AC output button to continue
operation.
Move the product to a cooler or
warmer area as needed, and allow
the product to reach the acceptable
operating temperature.
Disconnect some of the devices.
If condition persists, disconnect all
devices, and recharge the battery
packs.
Recharge the battery pack. If issue
persists, replace the battery packs.
Visit www.ryobitools.eu.
Call an authorised service centre.