Preliminary Operation-Not Connecting With Motor - Savch S900 Series User Manual

3. PRELIMINARY OPERATION-NOT CONNECTING WITH MOTOR

● Prior to connecting power supply with inverter, check and make sure that AC power supply voltage is within input
voltage range of the inverter.
● Connect power supply to L1/R,L2/S and L3/T input terminals of the inverter.
● Operation mode control selection
The operation mode can be divided into the following categories:
□ Operation command is controlled by panel.
(2-03=d0) (Factory setting)
□ Operation command is controlled by external terminals, STOP key on panel is valid.
Two line operation control, "FWD/STOP" and "REV/STOP"
(2-03=d1, 4-04=d1)
□ Operation command is controlled by external terminals, STOP key on panel is valid.
Two line operation control, "FWD / REV" and "OPERATION/STOP" control configuration.
(2-03=d1, 4-04=d2)
REV/STOP
FWD/STOP
RUN/STOP
REV/FWD
MI2
MI1
DCM
MI1
MI2
DCM
19
IM
IM
IM