General Warnings - Ferroli DIVAtop MICRO LN C Instructions For Use, Installation And Maintenence

DIVAtop MICRO LN C
EN

1. GENERAL WARNINGS

• Carefully read and follow the instructions contained in this instruction booklet.
• After boiler installation, inform the user regarding its operation and give him this manual,
which is an integral and essential part of the product and must be kept with care for future
reference.
• Installation and maintenance must be carried out by professionally qualified personnel,
in compliance with the current regulations and according to the manufacturer's instruc-
tions. Do not carry out any operation on the sealed control parts.
• Incorrect installation or inadequate maintenance can result in damage or injury. The
Manufacturer declines any liability for damage due to errors in installation and use, or
failure to follow the instructions.
• Before carrying out any cleaning or maintenance operation, disconnect the unit from the
electrical power supply using the switch and/or the special cut-off devices.
• In case of a fault and/or poor operation, deactivate the unit and do not try to repair it or
directly intervene. Contact professionally qualified personnel. Any repair/replacement of
the products must only be carried out by qualified personnel using original replacement
parts. Failure to comply with the above could affect the safety of the unit.
• This unit must only be used for its intended purpose. Any other use is deemed improper
and therefore hazardous.
• The packing materials are potentially hazardous and must not be left within the reach of
children.
• The unit must not be used by people (including children) with limited physical, sensory
or mental abilities or without experience and knowledge of it, unless instructed or super-
vised in its use by someone responsible for their safety.
• The unit and its accessories must be appropriately disposed of, in compliance with the
current regulations.
• The images given in this manual are a simplified representation of the product. In this
representation there may be slight and insignificant differences with respect to the prod-
uct supplied.
2. OPERATING INSTRUCTIONS
2.1 Introduction
Dear Customer
Thank you for choosing a FERROLI wall-mounted boiler featuring advanced design, cut-
ting-edge technology, high reliability and quality construction. Please read this manual
carefully since it provides important information on safe installation, use and mainte-
nance.
DIVAtop MICRO LN C is a high-efficiency and low emissions heat generator for heating
and domestic hot water production, running on natural gas or LPG, equipped with an
open-flue burner with electronic ignition and microprocessor control system, designed
for installation indoors or outdoors in a partially protected place (in compliance with EN
297/A6) for temperatures to -5°C (-15°C with optional antifreeze kit)
DIVAtop MICRO LN C A special internal device provides extremely fast hot water pro-
duction: on opening the tap, hot water is immediately available at the boiler outlet.
2.2 Control panel
Description of panel and display
12 1 14 2
11
13
27
26
24
3 25 23 4 22
fig. 1 - Control panel
Key
1 = DHW temperature setting decrease button
2 = DHW temperature setting increase button
3 = Heating system temperature setting decrease button
4 = Heating system temperature setting increase button
5 = Display
6 = Summer / Winter mode selection button
7 = Economy / Comfort mode selection button
8 = Reset button
9 = Unit On / Off button
10 = "Sliding Temperature" menu button
11 = Set DHW temperature reached
12 = DHW symbol
13 = DHW mode
14 = DHW outlet temperature / setting
15 = Eco (Economy) or Comfort mode
16 = External sensor temperature (with optional external probe)
19 15 5 16
7
ecomfort
bar
6
21 20 18 17
cod. 3540S350 - Rev. 05 - 03/2013
17 = Appears on connecting the external Probe or the Remote Timer Control (optionals)
18 = Room temperature (with optional Remote Timer Control)
19 = Burner On and actual power
20 = Antifreeze operation
21 = Heating system pressure
22 = Fault
23 = Heating delivery temperature / setting
24 = Heating symbol
25 = Heating mode
26 = Set heating delivery temperature reached
27 = Summer mode
Indication during operation
Heating
A heating demand (generated by the Room Thermostat or Remote Timer Control) is in-
dicated by flashing of the hot air above the radiator (details 24 and 25 - fig. 1).
The heating graduation marks (detail 26 - fig. 1) light up as the heating sensor tempera-
ture reaches the set value.
Domestic hot water (DHW)
A DHW demand (generated by drawing domestic hot water) is indicated by flashing of
the hot water under the tap (details 12 and 13 - fig. 1).
The DHW graduation marks (detail 11 - fig. 1) light up as the DHW sensor temperature
reaches the set value.
Comfort
A Comfort demand (reinstatement of temperature inside the boiler) is indicated by flash-
ing (detail 15 and 13 - fig. 1)
9 10
2.3 Lighting and turning off
Boiler not electrically powered
8
B
The antifreeze system does not work when the power and/or gas to the unit are
turned off. To avoid damage caused by freezing during long idle periods in win-
ter, it is advisable to drain all water from the boiler, DHW circuit and system; or
drain just the DHW circuit and add a suitable antifreeze to the heating system.
eco
bar
fig. 2
eco
bar
fig. 3
comfort
bar
fig. 4
fig. 5 - Boiler not electrically powered
EN
31