Specifications - Classe Audio CAP-2100 Owner's Manual

Specifications

All specifi cations are accurate at the time of printing. Classé reserves the right to
adjust specifi cations without notice.
Power output (both channels driven)
Frequency response
Phase
Signal-to-noise ratio
Channel separation
Noise floor (FFT)
Distortion (THD + noise)
Maximum input voltage
Voltage gain range
Sensitivity (SSP input)
Input Impedance
Output Impedance (main output)
Input complement
Output complement
Crosstalk (any input to any output)
Rated power consumption (as per IEC60065 - para.2.3.10)
Idle power consumption
Mains voltage
Dimensions (not incl. controls or connectors)
Shipping weight
Net weight
For more information, see your Classé dealer, or contact:
Classé Audio
5070 François Cusson
Lachine, Quebec
Canada H8T 1B3
Telephone +1 (514) 636-6384
FAX +1 (514) 636-1428
Internet: http://www.classeaudio.com
email: cservice@classeaudio.com
Classé and the Classé logo are trademarks of Classé Audio Inc. of Lachine, Canada. All rights reserved.
i-Command™ is a trademark of Equity International, Inc. All rights reserved.
AMX® is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved.
Crestron™ is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved.
100W/ch continuous rms @ 8Ω
200W/ch continuous rms @ 4Ω
10Hz – 22kHz (+0/-0.1dB)
10Hz – 155kHz (+0/-3.0dB)
better than 95dB @ 20kHz
(unweighted, 0.8Vrms/1kHz input, 10Hz – 80kHz)
0.5Vrms for rated output (single-ended)
1.0Vrms for rated output (balanced)
1 balanced (XLR), 4 single-ended (RCA)
specifi ed on rear panel decal
(cannot be changed by user or dealer)
less than -10° @ 22kHz
95dB typical
all peaks less than -90dBV
(10Hz – 80kHz)
0.005% @ 8Ω
3.8Vrms (single-ended)
7.8Vrms (balanced)
-100dB to +14dB
100kΩ
100Ω
2 single-ended (RCA)
better than -95dB
260W
125W
Width: 17.5" (445mm)
Height: 4.75" (121mm)
Depth: 16.5" (419mm)
59lbs (27kg)
50lbs (23kg)
43