Installing The Side Brush - Shark AI Ultra RV2600WDEU Instructions Manual

1 m
1 m
1.5 m
• Select a permanent location with strong Wi-Fi for the Charging Dock, because every time you relocate it,
your robot will have to completely re-map your house.
• Place the dock with its back against a wall and attach the landing mat. Select a level surface on bare floor,
in a central area. Do not place dock against baseboards or heating elements.
• Remove any objects that are closer than 1.5 metre from either side of the dock, or closer than 1 metre from
the front of the dock.
• Plug in the dock.

INSTALLING THE SIDE BRUSH

sha rkcl e a n.eu
DOCK SETUP
Snap the included Side Brush onto the square peg
on the bottom of the robot.
NOTE: Side brush design may vary.
IMPORTANT: The Shark® AI Ultra Robot has a pre-installed rechargeable battery. Charge the battery
completely before first use. It may take up to 6 hours to fully charge.
To TURN THE ROBOT ON: Place the robot on
the dock or hold down DOCK button for 5 to 7
seconds, until the indicator lights turn on.
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the dock.
If the robot doesn't return to dock, its charge may
have run out, or if it is in wet cleaning mode, the
dock may be blocked by carpet.
NOTE: When manually placing the robot on the dock, make sure the Charging Contacts on the bottom of the robot are
touching the ones on the dock. While the robot is charging, both white LED lights will flash. When the robot is properly
aligned on the dock, the battery icon on the robot will illuminate. When the battery is fully charged, the charging icon will
stop pulsing but will remain illuminated
NOTE: When picking up the robot, be careful not to place fingers between the bumper and the base of the robot.
CHARGING
If the robot has no charge or it cannot return to the
dock, manually place it on the dock. The indicator
light will turn blue and the robot will beep when it
is correctly placed on the dock.
s ha rkc lea n.eu