Shark AI Ultra RV2600WDEU Instructions Manual page 32

MAINTENANCE
CLEANING SENSORS AND CHARGING CONTACTS
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust off the sensors
and contacts located on the bottom of the robot and on the dock.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.
CLEANING SIDE BRUSH
CLEAN SIDE BRUSH AS NEEDED.
NOTE: Remove and replace the side brush if it is bent or damaged. To remove the brush, lift it off its peg.
sha rkcl e a n.eu
Carefully unwind and remove any string or hair
wrapped around the brush.
Gently wipe the brush with a dry cloth. To reinstall,
snap the brush over the peg. Spin the brush
manually to make sure it is installed correctly.
NOTE: Side brush design may vary.
MAINTENANCE
CLEANING THE WHEELS
CLEAN FRONT WHEEL PERIODICALLY.
See sharkclean.eu for replacement parts.
Clean the wheel housing.
NOTE: Brush not included.
Periodically clean the drive wheels and the housing
around them. To clean, rotate each drive wheel
while dusting.
s ha rkc lea n.eu