Vivint Smart Hub Lite Getting Started User Manual page 28

1. Yell "FIRE!" to alert everyone else.
2. If the panel is easily accessible and the alarm has not activated, go to the panel
and press the white lighted button, then press and hold down the Fire button on
the touchscreen for at least 2 seconds. This action triggers the panel fire alarm.
3. Evacuate all occupants from the house and call your local Fire Department from
a safe location outside your home.
Silencing a False Fire Alarm
If the fire alarm is sounding due to a detector sensing burnt food or some other non-
emergency condition, do the following:
1. Silence the fire alarm sirens by entering your User PIN at the panel.
2. Review the Alarm Memory to determine which sensor caused the alarm. If the
alarm restarts, there may still be smoke inside the detector's sensor. Re-enter your
User PIN to stop the alarm from continuing to sound.
3. If the alarm restarts, there may still be smoke in the detector's sensor. Enter your
user PIN again to stop the alarm. Fan the detector for 30 seconds to clear the
detector's sensor chamber.
4. After the problem has been corrected, go to the Alarm History screen, check Clear
Alarm History, and then press OK.
NOTE: Fire sensors that are still violated cannot be cleared from the Alarm
History screen until the device returns to normal operation. Carefully inspect your
home for fire or heat if your fire alarm remains in alarm state.
23