Set Up The Hub - Vivint Smart Hub Lite Getting Started User Manual

Set Up the Hub

This outline provides a summary of the installation of a Vivint Smart Hub Lite and the
sensors and devices that make up your system.
Setup and configuration, as well as subsequent control and usage of the system, is done
via the Vivint app. Follow the app's DIY setup screens to install and configure the hub
and add devices to the system.
General outline of steps for setting up the hub:
1. Unpack the box.
2. Plan ahead the best location for the hub (and other peripheral devices and
sensors).
3. Download the Vivint Smart Home app.
4. Scan the QR code on the bottom of the hub.
5. Place the hub in your chosen location.
6. Install the backup battery: Remove the cover on the bottom of the hub, firmly
push the battery into the bay where it connects with the contacts, and replace
the cover.
7. Plug the AC power supply into the selected wall outlet and connect it to the
power input on the back of the hub.
8. When the hub ID is recognized, the app launches the DIY hub setup procedure.
Follow the prompts and inline instructions that will guide you through the
following tasks: booting up, connecting to the local network, registering the
hub/system, creating a unique PIN code, testing the system, and updating
firmware.
When the hub is setup and registered you can complete system installation and
configuration by adding your security sensors and other devices.
6