Viessmann VITOTRONIC 300 Operating Instructions Manual page 14

Control unit operation
Overview of the "Main menu"
In the "Main menu", you can call up and adjust all of
the remaining settings for the control unit's range of
functions.
Menus available in the "Main menu":
Vitotronic 300
"Block/enable boiler"
"Boiler sequence"
"Test mode"
For the flue gas inspector only
"Settings"
E.g. – display brightness
"Heating"
For central heating settings, e.g.
"Time program".
"DHW"
For DHW heating settings, e.g. for the
"DHW temperature".
"Information"
To check operating data, e.g. temperatures
Energy saving function "Holiday pro-
gram"
"Service"
For contractors only
Using / you can scroll through the menu.
Information in the "Energy cockpit"
The "Energy cockpit" provides you with clear infor-
mation on the energy state of the components in your
heating system.
Note
The "Energy cockpit" is only shown if it was set up
during commissioning. If necessary, notify your con-
tractor.
Tap the following on-screen buttons:
1. If required, for the home screen
14
Call up the "Main menu" as follows:
■
■
■
Vitotronic 100
"Block/enable boiler"
—
"Test mode"
For the flue gas inspector only
"Settings"
E.g. – display brightness
– the
—
—
"Information"
To check operating data, e.g. temperatures
—
"Service"
For contractors only
Note
The menus available depend on your heating system
equipment.
Menu overview with all menus: See page 52.
2.
Note
When you call up the "Energy cockpit" for the first
time, you will be notified that the values shown cannot
be used for settling bills with the power supply utility.
■
■
Standby display active:
Tap anywhere on the screen and then tap
From the home screen:
Tap .
From anywhere in the menu:
Tap and then .
/ for "Energy cockpit"
The "Energy cockpit" is opened once you confirm
this notification with OK. This notification will not
appear again.
If you tap Cancel, the "Energy cockpit" will not be
opened. The notification will be shown again next
time.
.
Further details:
See page
31
34
40
31
22
28
36
26
—