Operation; Getting Started - Sony Trinitron PVM-20M7MDE Instructions Manual

Operation

Getting Started

LINE RGB/COMPONENT
A B A
DEGAUSS UNDER
SCAN
Notes
• After the power has been turned on or you have
pressed the DEGAUSS button on the front panel of
the monitor, the monitor is demagnetized for
approximately 10 seconds. This generates a strong
magnetic field around the monitor which may affect
data stored on magnetic tape or disks near the
monitor. Place all magnetic recording equipment and
tapes/disks well away from the monitor.
• Whenever you change the location of the monitor,
degauss the monitor before adjustments are made.
1
Set the power switch to ON and then turn on the
power on the other equipment.
We recommend warming up the monitor for at
least 30 minutes after turning the power switch on
and inputting the signal.
2
Adjust the monitor settings as required.
For detailed information on adjustments, see
"Adjustment" on page 18, "Main menu functions" on
page 22 and "USER SERVICE menu functions" on
page 26.
B MENU
APERTURE BRIGHT CHROMA CONTRAST VOLUME POWER
E X I T
RESET
SELECT
MIN MAX – + MIN MAX MIN MAX MIN MAX POWER
REMOTE ENTER SAVING
2
1
When the POWER SAVING indicator is lit
If no sync signals are received for a certain period, the
POWER SAVING indicator lights, and the monitor
screen blanks out. This is power saving mode.
Touching any button other than the POWER switch
will restore the monitor to normal operation.
Note
It takes about ten seconds for the picture to reappear
on the screen after power saving mode is released.
If the color display becomes non-uniform
Press the DEGAUSS button so that the color
uniformity becomes as even. If the color display
becomes non-uniform even after pressing the
DEGAUSS button, landing adjustment is required on
the on-screen menu.
For details, see "To adjust the landing" on page 27.
To display the whole picture on the monitor
Press the UNDER SCAN button so that the signal
normally scanned outside of the screen appears on the
monitor.
Note
When the monitor is in underscan mode, dark RGB
scanning lines may appear on the top edge of the
screen. These are caused by an internal test signal, and
are not part of the input signal.
17