Sony Trinitron PVM-20M7MDE Instructions Manual page 26

5 Repeat step 2 and 3 to adjust the bias.
The screen displays with the adjusted value,
but the data is not yet stored.
To reset the settings to the previous values
Press the >/+ and ./- buttons (these buttons
work as RESET button on the menu)
simultaneously.
6
Press the MENU button.
The adjusted values are stored in memory.
To activate the power saving function
Turn the power saving function on in the following
menu.
3POWER SAVING menu
Item Function
ON (30 MIN) Reduces the power consumption to
approx. 25%, 30 minutes after
sensing the absence of sync signal.
ON (10 MIN) Reduces the power consumption to
approx. 25%, 10 minutes after
sensing the absence of sync signal.
Turns off the power saving function.
OFF
To confirm the data set by the computer in
remote control mode
You can confirm the settings controlled from the
remote computer, such as volume, contrast, chroma,
brightness and aperture. When you select MEMORY
DATA IN REMOTE on the USER SERVICE menu
and press the ENTER button, the MEMORY DATA
IN REMOTE menu appears.
4MEMORY DATA IN REMOTE menu
To select the menu languages
You can select the menu language from the following
five languages: English, German, French, Italian and
Spanish on the LANGUAGE menu.
5LANGUAGE menu
To adjust the landing
If the color is not uniform even after you press the
DEGAUSS button, you can adjust the landing so as to
obtain color uniformity on the LANDING menu.
6LANDING menu
The following two methods are available to adjust the
landing.
One is to adjust landing as inputting the signal with
which the horizontal lines are displayed.
The other is to adjust landing as inputting the signal
with which the whole screen becomes whitish.
When inputting the signal for the horizontal lines
Adjust using the + and - buttons until the lines become
horizontal.
When inputting the signal with which the whole
screen becomes whitish
Adjust using the + and - buttons until the white color
becomes as uniform as possible.
To reset the setting to standard (00)
Press the >/+ and ./- buttons together.
27