Setting The Jumpers - Sony CDU711 User Manual

Setting the Jumpers

Notes for configuration jumpers:
12
Get user manuals: See SafeManuals.com
Set the jumper s on the rear of the drive in accor
configuration of your computer system.
The jumpers are preset at the "MASTER" position as illustrated at
the factor y.
• Designation of the Drive Number is generally set by inserting a
jumper pin on either the MASTER or the SLAVE pin.
• When the CDU711 is daisy-chained with a Hard Disk Drive on an
IDE Card, set the Hard Disk Drive as MASTER and the CDU711
as SLAVE.
• If the CDU711 is the only device connected to the IDE Card, set
the CDU711 as MASTER.
However, it should be noted that some per
CSEL in lieu of the f oresaid MASTER/SLA VE selection. In this
case , remo ve the e xisting jumper s fr om MASTER and SLA VE, and
set a jumper on CSEL.
connector is set lo
CSEL is set high, the drive is designated as Drive 1.
Consult y our PC man ufacturer , IDE Car d man ufacturer or dealer f
further details.
Installing the Drive Unit into the Computer
CSEL
SLAVE
MASTER
sonal computer
When the CSEL signal of the interface
w, the drive is designated as Drive 0.
dance with the
s ma y use
When the
or