Setting The Jumpers - Sony CDU701 User Manual

All manuals and user guides at all-guides.com

Setting the Jumpers

Set the jumper s on the rear of the drive in accor
configuration of y
The jumpers are preset at the "MASTER" position as illustrated at
the factor y.
Notes for configuration jumpers:
• Designation of the Drive Number is generally set by inserting a
jumper pin on either the MASTER or the SLAVE pin.
• When the CDU701 is daisy-chained with a Hard Disk Drive on an
IDE Card, set the Hard Disk Drive as MASTER and the CDU701
as SLAVE.
• If the CDU701 is the only device connected to the IDE Card, set
the CDU701 as MASTER.
However, it should be noted that some per
CSEL in lieu of the f oresaid MASTER/SLA VE selection. In this
case , remo ve the e xisting jumper s fr om MASTER and SLA VE, and
set a jumper on CSEL.
connector is set lo
CSEL is set high,
Consult y our PC man ufacturer , IDE Car d man ufacturer or dealer f
further details.
12
Installing the Drive Unit into the Computer
our computer system.
When the CSEL signal of the interface
w, the drive is designated as Drive 0.
the drive is designated as Drive 1.
dance with the
CSEL
SLAVE
MASTER
sonal computer s ma y use
When the
or