Touch Screen Interface Operation - Noztek fusionX User Manual

Hide thumbs Also See for fusionX:
Table of Contents

Advertisement

2. b
TOUCH SCREEN INTERFACE
1 - HOME
This screen shows all your settings, and appears red
to begin with as nothing has been set. As you define
settings, the corresponding boxes will turn green to
show that they are ready to go.
Press MENU to begin.
2 - MENU
This is where you control the settings. Use the three
'set' buttons to control the respective settings for the
run.
3 - SET TEMPERATURES
Here you can set the mixing temperature and the extrud-
ing temperature. Use the slider and/or the + and - but-
tons to control the settings.
You are able to set two temperatures, the extruding
temperature and the mixing temperataure. The warm-
up heater at the base of the barrel is for reference
ownly
Pressing SET will take you to the WARM UP screen
4 - WARM-UP
This screen has a timer to allow the machine to warm to
the correct temperature. You will not be able to escape
this screen until the warm-up is complete, at which time,
you will return to the HOME screen.

Advertisement

Table of Contents
loading

Table of Contents