Table of Contents
Advertisement
1. c
WARRANTY
• Equipment manufactured by Noztek carries the
standard machine tool guarantee of freedom
from defects in workmanship and material for one
year from date of shipment.
• TO INSURE THAT YOUR WARRANTY IS HELD IN
EFFECT, PROPER OPERATION PROCEDURES MUST
BE OBSERVED.
• NOTE: READ THE SAFETY PRECAUTIONS BEFORE
OPERATING THIS MACHINE.
1. d
SAFETY
1. Carefully read the instruction manual.
2. Learn the proper, safe use and limitations of the
equipment.
3. DO NOT operate or use this equipment for any
purpose other than its intended use.
4. DO NOT modify this equipment.
5. DO NOT perform adjustments or maintenance
while system is operating or energize
6. DO NOT clean the equipment with flammable
solvents.
7. DO NOT wash down the equipment with water.
This could cause an electrical hazard.
8. DO NOT probe into extruder vent with the ma-
chine running. Never Use a metal probe in
the vent area. The screw may shear the probe,
causing extensive damage to the barrel
and screw. A wooden probe is recommended.
9. DO wear a face shield, insulated gloves when
operating and when in close proximity to
the extruder during operation. These protective
items must also be worn when adjusting
the die, cleaning the screw, etc. The extruder tem-
peratures are extremely hot and failing to
protect yourself may cause serious injury.
10. The feed hopper MUST be installed on the ex-
truder feed section at all times when in operation
11. NEVER put hands in the feed section or vent to
remove material.
13. DO NOT switch on the motor until the recom-
mended temperature has been reached.
1. e
TECH SPECS
- 1000w rectangular ceramic heater (max tempera-
ture 500c)
- DAK Nozzle Band Heater 35D 25L 230-250V max
.210W (max temperature 450c)
- Auto switching 110v/220v Traco power supply
24V 10 amp
- Precision machined solid stainless steel barrel
- DC motor 17 RPM – 17 Nm torque
- Precision turned bespoke stainless steel mixing
screw
- 7 inch TFT touch screen
- Stainless steel micro hopper (with hopper weight)
- 1.75mm and 3mm stainless steel nozzles
- 3 sets ( 6 in total) of hardened steel cutting blades
10mm, 3mm and 1mm
2. a
POWER SWITCH AND START UP
To begin, first cuse the power switch on the side of
the machine to power up.
Powering up will take just a few moments, after
which you'll use the touch screen to set all extrud-
ing parameters and set the machine to begin.
Advertisement
Table of Contents
