Table of Contents
Advertisement
5 - SET SPEED
This sets your extrusion speed. Maximum speed is 17rpm
6 - SET TIMER
This represents the time you want to extrude the mate-
rial.
The machine will run for this set time once you have
switched on the motor. If no value is entered here, the
machine will run until you manually end the run your-
self.
7 - HOME (READY)
When you see that all boxes are green, you are ready to
extrude. Press the Motor box to begin.
Use the FAN ON/OFF toggle in the bottom right corner
to activate/deactivate the fan assistance at any time (fan
located under the heat-sink at the centre of the machine
(see diagram).
Press 'start cool down' when you are finished, this will
begin the shut-down process.
7 - COOL DOWN
This screen will show whilst the cool down is happening.
The preset is 62 minutes
Cancelling the cool down timer wll take you back to your
extrusion run.
Please run the full cool down beef before switching off
the machine.
Advertisement
Table of Contents
