Data Format; General Settings; Data Length - Marson MT1 User Manual

MT1 User's Manual V1.0

6. Data Format

Barcode data can be divided into various parts.
Code ID is often used to differentiate barcode data. Sometimes Preamble and
Postamble are used.
Data Format can achieve the following:
 Add [STX], [Code ID], [Preamble] to the beginning of barcode data.
 Add [Postamble], [Terminator] to the end of barcode data.
Full data format can be either one of following:
[STX] + [Code ID] + [Preamble] + [DATA] + [Postamble] + [Terminator]
[STX] + [Preamble] + [Code ID] + [DATA] + [Postamble] + [Terminator]
By default STX, Code ID, Preamble and Postamble are disabled; terminator is
0x0D (Carriage Return). If full data format is disabled, only DATA (original data
in a barcode) will be displayed. DATA can be further divided into [Start] +
[Center] + [End] if the length of Start/End is defined.

6.1 General Settings

When full data format is enabled, STX, Code ID, Preamble, Postamble and
Terminator become displayable if either of them is defined or enabled.
When full data format is disabled, STX, Code ID, Preamble, Postamble and
Terminator become non-displayable even if they are defined or enabled
individually.
Enable Full Data Format* Disable Full Data Format

6.2 Data Length

When Data Length is enabeld, two bytes of data, representng data length, will
be added to the beginning of barcode data.
___________________________________________________________________________________
41