Table of Contents
Advertisement
This function allows you to set the blow force of the fan while in the Manual Mode.
Pressing the ENCODER activates the fan. The fan will operate until the ENCODER is
pressed again.
Press the ENCODER to enable / disable the central heating pump.
Press the ENCODER to enable / disable the (water heater) hot
consumption water pump.
Press the ENCODER to enable / disable the alarm.
.5. Fuel Type
O
42
c
|
C.H.
Setpoint
This option allows you to select one of three fuel types (coal, fines
in the boiler. Each fuel type has a fan operation mode assigned to ensure the right
burning process.
.6. Central Heating Pump Activation
O
42
c
|
C.H.
Setpoint D
With this function, you can set the temperature that will activate the central heating
pump (the temperature is measured on the boiler). The pump will start if the setpoint
temperature is exceeded. The pump will be deactivated when the boiler temperature
Blow Force
Fan
Fan
C.H. Pump
C.H. Pump
H.C.W. Pump
H.C.W. Pump
Alarm
O
55
c
D
O
55
c
C.H. Pump Activation
Manual Mode
Fuel Type
Fuel Type
Coal
Fines
and wood) for use
o
35
c
C.H. Pump
Activation
9
Advertisement
Table of Contents
Need help?
Do you have a question about the EU-88 zPID and is the answer not in the manual?
Questions and answers