Related Manuals for Girard Systems 98GC1102
Summary of Contents for Girard Systems 98GC1102
- Page 1 IGNITION RETRACT & LOCK MODULE 98GC1102 INSTALLATION & PROGRAMMING GUIDE REV.12312015 RV AWNING PRODUCTS 1361 CALLE AVANZADO, SAN CLEMENTE, CA 92673 (800) 382-8442 FAX (949)276-5500 www.girardrv.com...
- Page 2 Shore Power – if connected; Generator Power – if the generator is running; Inverter Power – batteries must be charged for inverter operation. Girard Systems awnings are supplied with an electric motor appropriate to the product. Page 2 of 7...
- Page 3 These components must be electronically matched, programmed or paired before use. This is usually done at the Girard Systems factory. Should the need arise for the user to pair a device with the motor controller they must refer to the appropriate manual for the devices applicable to their particular installation.
- Page 4 Ignition Retract and Lockout module using the procedure described in this manual (see programming the delay). The 98GC1102 will send the retract signal 3 times in the first 5 seconds of the Vehicle engine starting or the parking brake being released, this will ensure that all electronically paired awnings have been sent a retract signal before the vehicle moves.
- Page 5 Page 5 of 7...
- Page 6 TO THE AWNING’S MOTOR CONTROL MODULE Figure 1 c) Connect the 12v wires of the 98GC1102 to the 12v ignition circuit or parking brake circuit of the vehicle. Note; When carrying out this part of the procedure each step must be executed within 10 seconds of the previous one or the module will revert to factory settings.
- Page 7 PROGRAMMING THE DELAY a) Remove the four screws on top of the 98GC1102 to open the Lid (See figure 2). UP Button SET Button Figure 2 Note; When carrying out this part of the procedure each step must be executed within 5 seconds of the previous one or the module will revert to factory settings.
Need help?
Do you have a question about the 98GC1102 and is the answer not in the manual?
Questions and answers