Related Manuals for Girard Systems GC946G
Summary of Contents for Girard Systems GC946G
- Page 1 12v DC IGNITION RETRACT MODULE GC946G INSTALATION GUIDE REV.12312015 RV AWNING PRODUCTS 1361 CALLE AVANZADO, SAN CLEMENTE, CA 92673 (800) 382-8442 FAX (949)276-5500 www.girardrv.com...
- Page 2 Shore Power – if connected; Generator Power – if the generator is running; Inverter Power – batteries must be charged for inverter operation. Girard Systems awnings are supplied with an electric motor appropriate to the product. Page 2 of 6...
- Page 3 It is normally mounted under the dashboard on a switched 12v DC circuit. Typically the ignition or parking brake circuit, so that when the circuit is made the GC946G will cause all of the awnings that have been programmed to retract.
- Page 4 UP BUTTON SET BUTTON MODE SELECT Fig. 1 The three Dip Switches of the GC 946G (Fig.1) determine its mode of operation. Fig.2 Shows the Dip Switches set as 1-ON / 2-ON / 3-OFF (The white square shows the position of the switch!). The function of switch 1 is to supply power to the transmitter and this is shipped in the “off”...
- Page 5 Remove the top cover and configure the DIP switches as shown in Fig.2 above. Supply power to the Motor Controller and the GC946G(Leave them on if already Press the PROGRAM button on the Motor Controller (the Green LED will start...
- Page 6 Connect the GC946G to a 12v DC supply. Press the P2 Button on the remote controller TWICE. Press the SET button on the GC946G ONCE (A beep will be emitted by the RF receiver). Fully extend the awning using the remote handset or switch and then press the UP button on the GC946G to verify that the unit is working properly (the awning should Retract).
Need help?
Do you have a question about the GC946G and is the answer not in the manual?
Questions and answers