Commissioning The System - Viessmann VITOCAL 200-G Installation And Service Instructions For Contractors

Further details regarding the individual steps

Commissioning the system

Commissioning (configuration, parame-
ter settings and function check) can be
carried out with or without the commis-
sioning wizard (see following chapter
and service instructions for the heat
pump control unit).
Commissioning with the commissioning wizard
The commissioning wizard automatically
guides you through all the menus where
settings have to be made. For this, "Cod-
ing level 1" is automatically active.
!
Please note
Incorrect operation at "Coding
level 1" may result in damage to
the appliance and the heating
system.
Observe the service instructions
for the "Vitotronic 200" heat pump
control unit, otherwise the appli-
ance warranty will be void.
Switch ON the ON/OFF switch on the
control unit.
■ The prompt "Start commission-
ing?" appears automatically on first
start-up.
Note
The commissioning wizard can also be
started manually:
To do this, press and hold
switching on the control unit (progress
bar visible).
Commissioning, inspection, maintenance
Note
The type and extent of the parameters
depend on the appliance type, on the
selected system scheme and the acces-
sories employed.
■ When the unit is first commissioned,
the display is in German.
Sprache
Deutsch
Bulgarski
Cesky
Dansk
Wählen mit
■ Manually switching some appliance
components during commissioning
enables the control unit to display
messages. These messages are not
appliance faults.
when
(cont.)
DE
ê
ç
BG
ê
CZ
ê
DK
ê
(
51