Corrosion Protection - BAC Vertex VRC A-1012N Series Operation & Maintenance Manual

5. Corrosion Protection

BAC products are constructed of corrosion-resistant materials. Other materials listed below are used in the equipment
construction:
•
Galvanized Steel Components: Inspect the galvanized steel components for blemishes or corrosion. Wire brush and
recoat the affected areas with a cold galvanizing compound such as zinc rich compound (ZRC).
•
Thermosetting Hybrid Polymer Components: Galvanized steel components protected with the thermosetting hybrid
polymer can be scratched, scraped, or blemished. To touch up these areas use a repair kit (BAC Part # 160133) available
from your local BAC Representative.
•
Stainless Steel Components: Inspect stainless steel components for signs of blemishes or corrosion. See section Long
Term Care of Stainless Steel on Page 33 for cleaning and care instructions.
•
TriArmor Corrosion Protection System: Inspect components protected with the TriArmor
®
System for signs of deep scratches or blemishes, especially in areas with field penetrations. Touch these up with 3M™
Windo-Weld™ Super Fast Urethane which is available through your local BAC Representative (BAC Part # RK1015).
Vertex™ Evaporative Condenser Operation & Maintenance Manual – Corrosion Protection
Corrosion Protection
®
Page | 29