Connections; Connect The Power Amplifier And The Vxs3S; Set The Line Voltage/Impedance And Power - Yamaha VXS3SB Owner's Manual

Connections

Connect the power amplifier and the VXS3S

Connect the OUTPUT of the power amplifier to the INPUT of the
subwoofer.
Power amplifier
INPUT
＋
－
6
VXS3SB / VXS3SW / CMA3SB / CMA3SW Owner's Manual
INPUT

Set the line voltage/impedance and power

Select the line voltage/impedance (70V/8Ω) and input wattage power tap
when using a 70V line distributed system.
NOTICE
• When using a low impedance connection, set the tap selector switch to the "8Ω"
position. Check the impedance shown around the tap selector switch, according to the
number of satellite speakers connected.
• When connecting speakers with high impedance, check the tap selector switch
settings indicated around the switch, and then set the tap according to the number of
satellite speaker connections (NONE/×2/×4) and the output (W).
Make sure that the input total of each speaker does not exceed the rated output of the
power amplifier.
• Do not set the tap selector switch to the "X" position.
If the setting is incorrect, it may cause malfunction of the speaker and amplifier.
• Make sure the amplifier is switched off before operating the tap selector switch.
High impedance connection
-Satellite speakers (NONE/×4)
Low impedance connection
-Satellite speakers (NONE/×2/×4)
High impedance connection
-Satellite speakers (×2)