Yamaha VXS3SB Owner's Manual page 15

6
Secure the speaker to the ceiling
6-1
Push the speaker into the ceiling, taking care not to pinch the cables.
NOTICE
When installing the speaker, make sure you do not touch the flaps or subject the
speaker to strong shocks. If the flaps become indented, the sound may become
distorted.
6-2
While lifting the speaker up slightly, use a screwdriver to turn the
screws clockwise and tighten the attachments screws.
The clamp opens when you begin turning the screw. As you
continue to turn the screw, the clamp slides down and pulls the
speaker into the ceiling.
NOTE
If the clamp is difficult to open, turn the screw counter-clockwise one-half revolu-
tion; this will make it easier to open.
Clamp
• To prevent stripping the screws, do not overtighten the screws.
• Do not turn any screws other than the attachment screws. This
7
Setting the line voltage/impedance and power
Flaps 7-1
8
Attach the hole cover sheets
8-1
9
Attach the grille
Attachment
screw
9-1
If the grille is not attached properly, it may fall off after the speaker
is installed.
Installing in a ceiling (using the CMA3S)
CAUTION
may cause the speaker to fall or malfunction.
Refer to page 6.
Attach the included hole cover sheets to the screw holes.
Align the grille to the front of the cabinet and attach the grille.
CAUTION
VXS3SB / VXS3SW / CMA3SB / CMA3SW Owner's Manual
15