Page 1
About satellite connection The SATELLITE connectors on the VXS10S/VXS10ST allow for the connection of satellite mid-high speakers to be used at the same amplifier output. This gives the benefit of reducing the number of amplifier channels and takes advantage of the high pass filter built in to the VXS10S/VXS10ST.
Page 2
Basic system Notes on connecting satellite speakers All satellite speakers must be set to 8 ohms (not 100V/70V taps) when connected to the satellite outputs of the VXS10S/VXS10ST. ■ VXS10S Connect so that the total combined impedance of the satellite speakers is 4 ohms or above per ST1 / ST2 connector.