Pre-Installation (Cable Preparation) - Yamaha VXS3SB Owner's Manual

Installing on a wall or ceiling

Pre-installation (cable preparation)

Strip the cable insulation as shown in the figure and connect the cables.
7-8 mm
Compatible cable: AWG12 (max. 3.5 sq)
NOTE
• Do not use solder to plate stranded wires, as this may cause the wires to break.
• Run the speaker cables to the installation area before installing the speaker.
1
Attaching the mounting bracket to the wall or ceiling
1-1
Determine the speaker installation location.
1-2
Refer to the figure below and determine where the mounting
bracket will be installed and where the cables will be fed.
175 or more
10
VXS3SB / VXS3SW / CMA3SB / CMA3SW Owner's Manual
Wall or ceiling
175 or more
Recommended area
40 30
for pulling out cables
Unit:mm
1-3
If you want to add space between the wall and the speaker,
attach spacers to the mounting bracket.
When securing at 4 points
1-4
Attach the mounting bracket to the wall or ceiling.
The 4 slots are for M6 screws, and the center hole's diameter is
11 mm.
1-5
Feed the cables from the wall or ceiling.
2
Attaching the safety wire
2-1
Attach the safety wire to the wall or ceiling.
CAUTION
• Use the included safety wire.
• Attach safety wire high enough so that there is not too much
slack in the wire.
• If the included safety wire is not long enough, consider the
weight of the speaker and the installation conditions, and pro-
cure an appropriate safety wire.
When securing at 1 point (center)